• Brand: Bradford White®
  • Inlet/Outlet Connection: 3/4 Inch Threaded
  • Applicable Standard: CSA
Power Direct Vent models are the solution to installations that lack sufficient air for combustion and require installation flexibility. All models can vent vertically or horizontally and are also approved for direct-vent, closed combustion applications.
  • Features and More


  • Bradford White Icon System™ - Intelligent Gas Control with Spark to Pilot Ignition System Eliminates the Constant Burning Pilot, This Results in Savings of Pilot Gas During Standby Periods (120 Volt AC)
  • Enhanced Performance - Proprietary Algorithms Provide Enhanced First Hour Rating and Tighter Temperature Differential
  • Advanced Temperature Control System - Microprocessor Constantly Monitors and Controls Burner Operation to Maintain Consistent and Accurate Water Temperature Levels
  • Intelligent Diagnostics - An Exclusive Green LED Light Prompts the Installer During Start-Up and Provides 10 Different Diagnostic Codes to Assist in Troubleshooting
  • Pilot on Indication - Flashing Green LED Provides Positive Indication that Pilot is On
  • Separate Immersed Thermowell - High Strength Advanced Polymer Composite Thermowell Provides Isolation between Electric Temperature Sensor and Surrounding Water, No Need to Drain the Tank when Removing Gas Valve
  • Closed Combustion Venting System - Power Direct Vent Models are Ideal for Installations which Lack Sufficient Air for Combustion, Such as New Construction Homes or Additions which are Tightly Insulated, This Models Use a Twin Pipe System Where Combustion Air is Drawn from Outside the Building in One Pipe and Combustion Products are Expelled to the Outside in Another Pipe
  • Cast Aluminum Air Intake Boot - a Cast Molded Air Intake Boot Design Provides Exceptional Durability During Installation and Operation
  • Horizontal and Vertical Venting - The Equivalent Foot of Intake Venting cannot be Greater than the Equivalent Foot of Exhaust Venting
  • Optional Concentric Vent Kit Termination - Termination Fitting Provides for Only One Exit Opening Through a Wall or Roof
  • Flammable Vapor Sensor - Electronic Sensor Prevents Burner Operation if Flammable Vapors are Detected, The Sensor will also Prevent Operation if there is Ongoing Flammable Vapors Burning Inside the Combustion Chamber
  • Factory-Installed Hydrojet Total Performance System - Sediment Reducing Device that also Increases First Hour Rating of Hot Water While Minimizing Temperature Build-Up in Tank
  • Vitraglas Lining - an Exclusively Engineered Enamel Formula that Provides Superior Tank Protection from the Highly Corrosive Effects of Hot Water, This Vitraglas Formula is Fused to the Steel Surface by Firing at a Temperature of Over 1600 Deg F
  • Insulation System - Non-CFC Foam Insulation Covers the Sides and Top of the Tank, Reducing Heat Loss, This Results in Less Energy Consumption, Improved Efficiencies and Jacket Rigidity
  • Factory Installed Heat Traps - Design Incorporates a Flexible Disk that Reduces Heat Loss in Piping and Eliminates the Potential for Noise Generation
  • Protective Magnesium Anode Rod - Provides Added Protection Against Corrosion for Long-Term, Trouble-Free Service
  • Energy Star® Rated
  • Lead-Free
  • AHRI Certified


    Bradford White ICON System, Advanced Temperature Control System, Separate Immersed Thermowell, Closed Combustion Venting System, Cast Aluminum Air Intake Boot, Flammable Vapor Sensor, Factory-Installed Hydrojet Total Performance System, Factory-Installed Heat Trap, Protective Magnesium Anode Rod, Hydrojet Total Performance System